NEO suspender Manuel D'utilisation page 20

EN
Installation of the protection in the harness
The protection NEO-Koroyd is integrated in the Suspender. The harness is delivered
with the protection installed in a pocket, which is accessed by 2 zips on the side of
the geometry. In case of heavy impact, you should replace the protection. Follow the
steps below to install the new protection.
Remove a carabiner and open the zips that hold the rescue container on each side,
to facilitate the opening of the protection pocket aperture.
Slide the protection from above and check the emergency webbing remains in the
correct position between the back of the harness and the back protection.
Replace the protection and close the zips of the rescue container. To reinstall the
carabiner please refer to the section « carabiners installation ».
38
Information
The protection NEO-Koroyd 1.0 is designed to absorb the energy of an impact
by partial damage or complete destruction of the material. In case of high energy
impact, a visual inspection of the protection is advised to evaluate the level of material
deformation.
In case of doubt, contact your local NEO reseller.
No modification should be made to the protection which could affect its characte-
ristics. It should only be used for paragliding.
The protection doesn't guarantee total protection against injury, and even then only
the body parts covered are protected.
EN
39