Axis Q1604-E Guide D'installation page 22

AXIS Q1604-E Network Camera
3. Set the camera to its extreme distant-focus position by loosening the focus puller and
turning the focus ring fully clockwise.
4. Press and quickly release the control button. When the status indicator flashes green, the
Focus Assistant is enabled. If the status indicator flashes either red or amber before you
are able to adjust the lens, skip to step 7 to exit the Focus Assistant and repeat steps 3–7.
5. Gently turn the focus ring anti-clockwise until it stops.
6. Finally, turn the focus ring slowly clockwise until the status indicator flashes green
or amber (not red).
7. To exit the Focus Assistant, press the control button. The Focus Assistant is switched off
automatically after 15 minutes.
8. Retighten the focus puller.
9. Open the Live View page in the web browser and check the quality of the image.
10. Continue with steps 6–8 on page 20.
Access the Product
AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products
on the network and assigning them IP addresses in Windows®. Both applications are free and can
be downloaded from www.axis.com/techsup
The product can be used with most operating systems and browsers. The recommended browsers are
• Internet Explorer
®
• Safari with OS X
TM
• Chrome or Firefox
For more information about using the product, see the User Manual available at www.axis.com
Replace the Lens
Note
There is no need to restart the product after changing the lens. However, the product must
be restarted if you are interchanging between a P-Iris, DC iris or fixed/manual iris lens. In
order to set the focus and position the lens, the product must be connected to the network.
It is possible to use optional lenses for the Axis product.
To replace the lens:
1. Disconnect the iris cable.
2. Unscrew the standard lens.
3. Attach and screw on the new lens.
® ®
with Windows
®
®
with other operating systems.
22