Axis Q1604-E Guide D'installation page 19

3. Route the network cable through the hole and plug the cable gasket to the hole.
4. Connect the cables, see Connect the Cables.
5. Take the top cover and attach the safety wire to the tab on the bottom cover.
6. Loosen the bracket adjustment screw to point the camera in the right direction. See
page 22 for information on how to view the video stream.
Adjust the focus, see page 20.
7. Install the top cover. Make sure to tighten diagonally opposite bottom cover screws a
few turns at a time until all are tight. This will help ensure that the bottom cover gasket
is compressed evenly. Do not tighten the screws completely the first time.
8. Install the cable cover and tighten the cable cover screws.
9. Loosen the sunshield adjustment screws and adjust the sunshield to the front position.
Connect the Cables
1
Network cables
2
I/O cable
3
Bottom cover
AXIS Q1604-E Network Camera
19