Axis Q1604-E Guide D'installation page 20

AXIS Q1604-E Network Camera
1
Network connector (PoE OUT, connected at delivery)
2
Cable holes
3
Network connector (PoE IN)
4
LED indicator
5
Arctic Temperature Control switch
6
Alarm output (connected at delivery)
1. Optionally insert an SD memory card (not included) into the SD card slot. A standard or
high capacity SD card is required to store images locally in the camera.
2. Optionally connect external input/output devices. See Connectors on page 14 for
information on the connector pins. See Route the Network Cable Through the Cable Hole
on page 17 for information on preparing the network cable. Route the cables through
the cable holes into the bottom cover and to the camera.
3. Connect the camera to the network using a shielded network cable and using the
network connector (PoE IN) on the bottom cover. The network cable and the I/O cable
between the bottom cover and the camera, are already connected at delivery.
4. Check that the indicator LEDs indicate the correct conditions. See LED Indicators on
page 11 for further details.
Adjust Focus
To adjust the zoom and focus follow these instructions:
20