Publicité
Les langues disponibles
Les langues disponibles
Power button – press the
1.
conditioner on and off. Never turn the appliance off by unplugging from the power source.
Always press the power button, then wait for a few minutes before unplugging. This allows the
appliance to perform a proper shutdown.
Cool Mode – press the
2.
the target temperature 64°-90° F (18°-32° C) by pressing the
corresponding value is displayed. Select the required fan speed by pressing the fan
speed button.
Dry Mode – press the
3.
appear on the screen. In this model, the default fan speed is low, and cannot be modified.
Fan Mode – press the
4.
select your desired fan speed, either High
Sleep Mode - press the SLEEP button on the remote control (there is no sleep mode on the
5.
control panel). This function is useful when you are sleeping as it gradually reduces operation
of the appliance. To set this function correctly, select the cool or dry mode as described above.
Press the
button. The appliance operates in the previously selected mode.
When you choose the sleep function, the brightness of the screen is reduced and fan speed
is lowered.
The SLEEP function maintains the room at optimum temperature without excessive fluctuations
in either temperature or humidity with silent operation. Fan speed is always at Low, while room
temperature and humidity vary gradually to ensure comfort.
When in COOL mode, the selected temperature will decrease by 1° per hour in a 2 hour period.
This new temperature will be maintained for next 6 hours and then the appliance will turn off. The
SLEEP function can be canceled at any time during operation by pressing the "Sleep", "Mode" or
"Fan Speed" button.
In FAN or DRY mode, SLEEP function cannot be set.
Directional Louvers – Control the direction of the
1.
air flow by manually adjusting the deflectors to the
desired direction. In shipping, the vents are closed
and must be opened by pushing on the bottom left
hand corner deflector to open.
Note: The Louver Swing Button
however that feature is not available on this model.
Setting the Timer using the control panel or remote control
Programming Start Up –
• Turn on the appliance, choose the mode you want, for example cool, 72°F, high fan speed.
• Turn off the appliance.
• Press the Timer button, the
• Press several times until the corresponding time is displayed.
• Wait about 5 seconds, the timer will be active, then the "Timer" symbol is displayed on
the screen.
• Press the Timer button again, the timer will be canceled, and the "Timer" symbol will disappear
from screen.
on the control panel or the remote control to turn the air
on the control panel or remote until the Cool mode is lit. Select
on the control panel or remote until the Dry symbol appears, "dh" will
on the control panel until the Fan symbol appears. You can then
is on the remote,
symbol and the screen will display 1-24 hours.
7
or Low
.
A
Horizontal
Deflector
or
button until the
Vertical
Deflector
B
Publicité
