Publicité
Les langues disponibles
Les langues disponibles
SWING Function
The swing
function on the remote can be used to allow the air deflector to swing continuously.
To enable press the power (Insert button image) on the remote to enable the deflector to swing
continuously. Press again to cause the deflector to stop in the desired position.
Power button – press the
1.
conditioner on and off. Never turn the appliance off by unplugging from the power source.
Always press the Power button, then wait for a few minutes before unplugging. This allows
the appliance to perform a proper shutdown.
Cool Mode – press the
2.
the target temperature 18° - 32°(64°-90°) by pressing the
corresponding value is displayed. Select the required fan speed by pressing the fan
speed button.
Dry Mode – press the
3.
will appear on the display. In this model, the default fan speed is low, and cannot be selected.
Fan Mode – press the
4.
select you desired fan speed, either High
Sleep Mode - press the SLEEP button on the remote control (there is no sleep mode on the
5.
control panel). This function is useful when you are sleeping as it gradually reduces operation
of the appliance. To set this function correctly, select the cool or dry mode as described
above. Press the
selected mode.
When you choose the sleep function, the brightness of the screen is reduced and fan speed
is lowered.
The SLEEP function maintains the room at optimum temperature without excessive fluctuations
in either temperature or humidity with silent operation. Fan speed is always at Low, while room
temperature and humidity vary gradually to ensure your comfort.
When in COOL mode, the selected temperature will decrease by 1° per hour in a 2 hour period.
This new temperature will be maintained for the next 6 hours and then the appliance will turn off.
The SLEEP function can be canceled at any time during operation by pressing the "Sleep", "Mode"
or "Fan Speed" button.
In FAN or DRY mode, SLEEP function cannot be set.
Setting the Timer using the control panel or remote control
Programming Start Up –
• Turn on the appliance, choose the mode you want, for example cool, 72°F, high fan speed.
• Turn off the appliance.
• Press the Timer button, the
• Press several times until the corresponding time is displayed.
• Wait about 5 seconds, the timer will be active, then the
the screen.
• Press the Timer button again, the timer will be canceled, and the
from screen.
on the control panel or the remote control to turn the air
on the control panel or remote until the Cool mode is lit. Select
on the control panel or remote until the Dry symbol appears, "dh"
on the control panel until the Fan symbol appears. You can then
button. The appliance operates in the previously
symbol and the screen will display 1-24 hours.
or
or Low
.
symbol is displayed on
13
button until the
symbol will disappear
Publicité
