Antari B-200 Mode D'emploi page 7

it has built-in DMX and can be controlled using one channel.
To connect the wireless or timer remote control, plug the stereo jack into the socket
labeled REMOTE CONTROL on the back of the bubble machine. The socket is located to
the left of the dip switches.
Without remote control:
Turn on the device via the power switch located on the back of the bubble machine. The
internal bubble drum begins to rotate and the internal fan is activated. Bubbles are now
constantly generated until the power is switched off.
DMX Connector Pin Assignment
5 pin XLR connector for DMX connection.The diagram below indicates pin assignment
information
Using DMX to control the B-200:
Set the desired DMX channel using the dip switches at the back of the machine.
Connect the bubble machine to the DMX chain using the input and output sockets.
NOTE: The machine uses only one DMX channel. This channel does not control bubble
volume, it only controls on & off functions.
DMX protocol
Addressing
Each device occupies 1 channel. To ensure that the control signals are properly directed
to each device, the device requires adressing. This is to be done for every single device by
changing the DIP switches as set out in the table below.
The starting address is defined as the first channel from which the device will respond to
the controller. Please make sure you don't have any overlapping channels in order to
control each device correctly and independently from any other device on the DMX data
link. If two, three or more devices are addressed similarly, they will work similarly.
Pin
1
2
3
4
5
DMX value
0 -128
129-255
Function
Ground
Data-
Data+
N/A
N/A
Feature
OFF
ON
6