Antari B-200 Mode D'emploi page 4

Before beginning with the initial setup of your Bubble Machine, make sure that there is no
evident damage caused by transportation. In the event that the unit's housing or cable is
damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI
dealer for assistance.
Setup
Remove all packing materials from shipping box. Check that all foam and plastic
․
padding is removed, especially in the nozzle area.
Place the bubble machine on a flat surface.
․
Loosen the side screws at the front of the B-200 and lift the top of the case up. This
․
will expose the liquid tray where the bubble liquid is added. Fill the liquid to no more
than 3 cm from the top of the tray.
Pour the bubble liquid into the liquid tray, DO NOT OVERFILL.
․
When the container is full, lower the housing and tighten the screws.
․
Attach the hanging bracket with the included tightening and metal screws.
․
Attach the M8 safety ring. This hooked safety ring can double insure the machine from
․
falling down when installed at high positions.
The B-200 Bubble machine can now be positioned in the desired location. Be careful
․
to keep the machine even while moving and installing otherwise liquid may spill out of
the liquid tray. This is particularly important when the mounting bracket is used to
suspend the B-200.
Once the machine is securely positioned and a final check is made to insure that no
․
liquid has leaked, connect the power cord to the electrical supply. If there is any
leakage or moisture on the machine, the cord or the remote, leave the machine
unplugged until the B-200 is dry.
3