Publicité
Les langues disponibles
Les langues disponibles
A S S E M B LY A N D O P E R A T I O N
TOOLS REQUIRED FOR
ASSEMBL Y
• Wrench for M6 hex bolts
• Wrench for M8 hex bolts
ASSEMBL Y
• SIDE HANDLE ATTACHMENT:
Note: Holes in the cabinet are tapped
requiring no nuts for installation.
Side handle should be mounted on the
same side of the cabinet as the swivel
casters.
Attach the side handle using M6 hex
bolts.
Tighten the bolts with wrench.
• CASTER INSTALLATION:
Note: Use adequate manpower for this
operation.
Lay the cabinet down on its back.Use
packaging material to protect the paint
finish .
Mount both swivel casters on the same
side of the cabinet as the handle.
Attach each caster using four M8 hex
bolts per caster.
Wrench tighten all bolts.
Return the cabinet to its upright position.
OPERATION
• TO REMOVE DRAWERS:
Empty the drawers.
Pull drawer out so that it's almost fully
extended.Push up right hand black release
lever, while pulling down left hand black
release lever.
While holding the levers in the positions
as instructed above, pull the drawer out-
ward until it is released from the drawer
slide.
• TO REPLACE DRAWERS:
Empty the drawers.
Extend the drawer slides from the tool
chest.
Insert the brackets on each side of the
drawer into the slots in the cabinet slides,
being careful that they are properly in
position.
Once properly inserted, completely close
the drawer to set the slides into their proper
positions.
3
Publicité
