Installation Of The Stove; Installation Sequence - Olsberg Konigshutte Lima Instructions

Installation of the stove

even and horizontal. The stove must only be installed
combustible spark protection plate must be used. This
spark protection plate must project beyond the com-
bustion chamber opening of the stove, 50 cm to the
front and 30 cm to the side.
A protective panel is not required under the stove and
under the waste gas pipe.
95 mm
1
2
Fig.1
1 Main switch
2 Combustion air duct
3 Room temperature sensor
4 Socket for the connection plug
5 Connecting cable
6 Connection duct - waste air pipe
40
3 4 5 6

Installation sequence

Determine the installation location. Objects made
be placed in the radiation area of the wood-burn-
-
ing stove to a distance of 80 cm, measured from the
view pane of the combustion chamber door.
Depending on the installation position of the stove in
or load-bearing), the following distances from walls
need to be observed in accordance with the position
of the combustion chamber door to the wall / side
panel or the back panel (see schematic diagram).
When not dealing with walls that need to be protect-
ed, you merely need to observe a minimum distance
of approx. 5 cm to allow for proper heat
5
Stove installed straight in corner
5
Stove installed diagonally in corner
dissipation..
5
Dimensions in cm
Dimensions in cm