Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
7
Tighten the dowels (13) pre-inserted in the bracket with a 24,6 Nm [18,14 lb∙ft] tightening torque by means
of a hex key (12).
8
If necessary, proceed with the fine adjustment (paragraph 2.3) otherwise proceed directly to tighten the
ring nut (step 2, paragraph 2.3).
DANGER
If the ring nut is not tightened while using the bar, this can cause damage to people or things.
2.3 Fine adjustment
After installation and before tightening the ring nut (1), it may be necessary to finely adjust the length of the bar
in order to obtain the correct alignment of the engines.
1
Using a 22 mm wrench act on one of the end
elements (3) or (2) and carry out the fine adjust-
ment of the bar length.
2
Once the fine adjustment has been carried out, tighten the
ring nut (1) using a 22 mm wrench with a tightening torque
of 40 [Nm] (29.52 [lb ∙ ft]) by means of a second wrench on
the end element (2).
WARNING
Check if the engine can also tilt independently and in different
steering positions.
CAUTION
In no event shall the bar and/or its connections constitute a
limitation to the steering allowed by the installed steering
system and to the lifting of the engines.
13
Installation and Maintenance Manual
12
2
3
2
page 11
-
TIE BAR A96
1
of 47
Publicité
Chapitres
Table des Matières
