FAAC TM2 E Mode D'emploi page 18

RESTORING THE ORIGINAL CONFIGURATION
Carry out the following procedure to restore the original configuration of the motor:
- connect the Brown and Black wires of the motor to the same button e.g. UP
- press the UP button for at least 2 seconds
- disconnect and restore the electrical connection of the control buttons.
MOTOR OPERATION AT OPEN AND CLOSED LIMIT STOP
TM2 E
TM2 E
SU DOWN
POSITIONS AND OBSTACLES
OPEN AND CLOSED LIMIT STOPS
(roller shutter with plugs and/or
rigid straps).
Normally stops a few mm before the
limit stop. Occasionally travels as far as
possible and does not reverse slightly
to decrease the force.
1- brown
2- black
3- blue
4- yellow-green
OBSTACLE DETECTION DURING VERTI-
CAL MOVEMENT
(during downward movement only
for roller shutters with rigid straps).
Stops and does not reverse the move-
ment.
18 A4516_6J97_Rev.A