Weston 36-2001-W Mode D'emploi page 6

8. While holding the Mixing Shaft in
place, pull the Pivot Knob out until
it stops. Align the Mixing Shaft with
the Brass Pivot Pin. Slowly release
the Pivot Knob to allow the Brass
Pivot Pin to seat in the Bushing
(FIGURE 4).
9. Tighten the second Set Screw
under the Pivot Knob Post until it
stops (make sure the Set Screw
fits in the notch on the Pivot Knob
shaft). Loosen the Set Screw ½
turn to allow the Pivot Knob to
rotate freely (FIGURE 5).
10. Install the Handle onto the Drive
Shaft.
11. Install the Clear Lid (FIGURE
6). DO NOT use the Meat Mixer
without the Clear Lid in place.
Severe injury could result!
KEEP FINGERS AND HANDS AWAY from the Mixing Shaft and Paddles during use. NEVER reach into the MIxing Tub
NEVER reach into the Mixing Tub with an elcetric grinder attached to the Meat Mixer and connected to a power source.
KEEP CHILDREN AWAY. NEVER LEAVE THE MEAT MIXER UNATTENDED. SEVER INJURY MAY RESULT.
Make sure the Mixer is completely assembled and all parts are locked into position before using.
READ & FULLY UNDERSTANF ALL INSTRUCTIONS & WARNINGS PRIOR TO USING THIS UNIT. YOUR SAFETY IS
6
CAUTION!
while the Mixing Shaft and Paddles are in motion.
ALWAYS disconnect the electric grinder from the Meat Mixer when not in use.
DO NOT mix bones or other hard objects.
MOST IMPORTANT.
Mixing Shaft
Pivot Pin
(Inside)
Pivot
Knob
Post
Set
Screws
Clear
Lid
FIGURE 4
Pivot
Knob
FIGURE 5
FIGURE 6