Wet And Dry Applications; Maintenance And Repairs - Blastrac BDC-23-230V-P Manuel D'instructions

Instruction manual BDC-23-230V-P_ BDC-23-110V-P

Wet and dry applications

The supplied filters and the bag (if applicable) must be
installed correctly.
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
If the version for liquids is used:
■ Make sure the liquid level sensor is working
correctly before vacuuming liquids.
If foam forms, turn off the vacuum cleaner
■
immediately and empty the container.
■ Warning: Switch off the vacuum cleaner
immediately if foam or liquid leaks out.
■ Regularly clean the liquid level limiting device
and check to make sure that there are no signs
of damage.
■ Warning: Dirty liquid vacuumed up by
the vacuum cleaner must be considered
conductive.
Vacuum cleaner for liquids.
When vacuuming a mix of water and air, take care
to avoid overloading the motor of the vacuum unit.
I
US
[ NOTE ]
WARNING!
WARNING!
WARNING!

Maintenance and repairs

WARNING!
Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts or
converting it to another version/variant, the plug
must be disconnected from the socket.
■ Carry out only the maintenance operations
described in this manual.
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety.
www.blastrac.com ‒ info@blastrac.com
6/16