Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply; Extensions - Blastrac BDC-23-230V-P Manuel D'instructions

Instruction manual BDC-23-230V-P_ BDC-23-110V-P

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight).
Setting to work - connection to the
power supply
WARNING!
■ Make sure there is no evident sign of damage
to the vacuum cleaner before starting work.
Before plugging the vacuum cleaner into the
■
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that
of the electrical mains.
Plug the vacuum cleaner into a socket with a
■
correctly installed ground contact/connection.
■ Make sure that the vacuum cleaner is turned
off.
■ The plugs and connectors of the connection
cables must be protected against splashes of
water.
■ Make sure that connections to the electrical
mains and plug are correct.
Use the vacuum cleaners only when the cables
■
that connect to the electrical mains are in
perfect condition (damaged cables could lead
to electric shocks!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the
electric cable.
WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
Only disconnect the cable from the electrical
■
mains by removing the plug (do not pull the
cable).
Only replace the electric power cable with one
■
of the same type as the original: H07 RN - F.
The same rule applies if an extension is used.
The cable must be replaced by the
■
manufacturer's Service Centre staff or by
equivalent qualified personnel.

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Minimum section of extension cables: 2.5 mm
Maximum length = 20 m
Cable = H07 RN - F
WARNING!
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the
data plate.
WARNING!
Never spray water on the vacuum cleaner: this
could be dangerous for persons exposed and could
short circuit the power supply.
WARNING!
The vacuum cleaner's power socket must be
protected by a differential circuit-breaker with
surge current limitation, that shuts off the power
supply when the current discharged to the ground
exceeds 30 mA for 30 msec. or an equivalent
protection circuit.
www.blastrac.com ‒ info@blastrac.com
5/16
2
I
US