Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating manual BDC1330 DBP/LPP
Setting to work - connection to the
power supply
WARNING!
■
Make sure there is no evident sign of damage
to the vacuum cleaner before starting work.
■
Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that
of the electrical mains.
■
Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
■
Make sure that the vacuum cleaner is turned
off.
■
The plugs and connectors of the connection
cables must be protected against splashes of
water.
■
Make sure that connections to the electrical
mains and plug are correct.
■
Use the vacuum cleaners only when the cables
that connect to the electrical mains are in
perfect condition (damaged cables could lead
to electric shocks!).
■
Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the electric
cable.
WARNING!
When the vacuum cleaner is operating, do not:
■
Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■
Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■
Only replace the electric power cable with one
of the same type as the original; the same rule
applies if an extension is used.
■
The cable must be replaced by the
manufacturer's Service Centre staff or by
equivalent qualified personnel.
Extensions
▪
If an extension cable is used, make sure it is
suitable for the power input and protection degree of
the vacuum cleaner.
EU version
Minimum section of extension cables: 2.5 mm
Maximum length = 20 m
Cable = H07 RN - F
US version
Minimum section of extension cables: 12 AWG
Maximum length = 66 ft
Cable = SJT
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the
data plate.
Never spray water on the vacuum cleaner: this
could be dangerous for persons exposed and could
short circuit the power supply.
The vacuum cleaner's power socket must be
protected by a differential circuit-breaker with
surge current limitation, that shuts off the power
supply when the current discharged to the
ground exceeds 30 mA for 30 ms or an equivalent
protection circuit.
Dry applications
The supplied filters and the bag (if applicable) must be
installed correctly.
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
Maintenance and repairs
Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts
or converting it to another version/variant, the
plug must be disconnected from the socket and
controlled by the operator.
2
■
Carry out only the maintenance operations
described in this manual.
■
Use only original spare parts.
■
Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately make the EC declaration of conformity
issued with the vacuum cleaner void.
5/14
WARNING!
WARNING!
WARNING!
[ NOTE ]
WARNING!
WARNING!
info@blastrac.eu
GB
Publicité
Table des Matières
Dépannage
