Setting To Work - Connection To The Power Supply; Extensions; Dry Applications; Maintenance And Repairs - Blastrac BDC 3140 DBP-3020 Manuel D'instructions

Instruction Manual BDC3140 DBP/LPP-3020
Setting to work - connection to the
power supply
WARNING!
■ Make sure there is no evident sign of damage
to the vacuum cleaner before starting work.
Before plugging the vacuum cleaner into the
■
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that
of the electrical mains.
■ Connect the plug into a socket with a correctly
installed ground contact/connection. Make
sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection
cables must be protected against splashes of
water.
Check that for proper connection to the
■
electrical mains.
Use the vacuum cleaners only when the cables
■
that connect to the electricity mains are in
perfect condition (damaged cables could lead
to electric shocks!).
Regularly check there are no signs of damage,
■
excessive wear, cracks or ageing on the electric
cable.
WARNING!
When the device is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■ Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■ Only replace the electric power cable with
one of the same type as the original: H07
RN - F (400V/50Hz), SOOW (230V/60Hz
- 440V/60Hz), the same rule applies if an
extension is used.
The cable must be replaced by the
■
manufacturer's Service Centre staff or by
equivalent qualified personnel.

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Minimum section of extension cables:
Maximum length = 20 m
Cable = H07 RN-F (400V/50Hz), SOOW (230V/60Hz-
440V/60Hz)
Max power (kW)
Minimum section (mm )
2
WARNING!
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the
data plate.
WARNING!
The vacuum cleaner's power socket must be
protected by a differential circuit-breaker with
surge current limitation, that shuts off the power
supply when the current discharged to the ground
exceeds 30 mA for 30 msec. or an equivalent
protection circuit.
WARNING!
Never spray water on the vacuum cleaner: this
could be dangerous for persons and could short
circuit the power supply.

Dry applications

[ NOTE ]
The supplied filters and the bag (if applicable) must be
installed correctly.
WARNING!
Comply with the safety regulations governing the
vacuumed materials.

Maintenance and repairs

WARNING!
Disconnect the vacuum cleaner from its power
source before cleaning, servicing or replacing parts;
the plug must be removed from the socket.
■ Carry out only the maintenance operations
described in this manual.
Use only original spare parts.
■
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately void the EC declaration of conformity
issued with the device.
www.blastrac.eu ‒ info@blastrac.eu
5/16
3 5
2.5 4
GB