Teesa TSA2011 Manuel D'utilisation page 24

24
This iron is equipped with a drip-stop function: when the iron's temperature is too low, the
steaming function automatically stops to prevent water from dripping out of the soleplate.
If the iron is connected to power mains and not moved for a certain period of time, an
internal safety feature will activate auto shut off function. In about 8 minutes (when in vertical
position) or 30 seconds (while horizontally), if not moved, the device will issue sound signals
and the auto-off indicator will blink. After few seconds, the sound signals will be muted and
the auto-off indicator will be still blinking, which means the iron has been automatically
switched off. Move the appliance sharply to switch it on again.
The Anti-calc function filtrate the minerals from the water to prevent mineral residue build
up at the steam chamber.
EN
• Check and follow the ironing instructions for the garment to be ironed.
• If the garment does not have any ironing instructions but you know the kind of fabric in
question, use the chart provided in this manual.
• Fabrics that have some kind of finish (polishing, wrinkles, contrasts, etc.) can be ironed at
the lowest temperatures.
• If the fabric contains several kinds of fibers, use the lowest temperature recommended
for the fibers in the blend; if an article contains 60% polyester and 40% cotton, you must
choose the temperature corresponding to polyester and iron without steam.
• Group the articles to be ironed, according to their ironing temperature: wool with wool,
cotton with cotton, etc.
• The iron heats up quicker than it cools down. Start by ironing the articles requiring the
lowest temperature (such as those made of synthetic fibers), and move towards those that
require higher temperatures.
• Silk and other fabrics that are likely to become shiny should be ironed on the inner side.
Velvet and other textures that rapidly become shiny should be ironed in one direction
with light pressure applied.
• Always keeps the iron moving at all times.
• Pure wool fabrics (100% wool) may be ironed with the steam iron. Set temperature to
the one designed for wool, select a high steam position and use a dry ironing cloth over
the material. NOTE: When ironing woolen fabrics, shining of the fabric may occur, so it is
suggested that you should turn the article inside out and iron the reverse side.
• Please note, steam functions is not to be used in lowest temperature setting (dripping
may occur).
• Steam ironing eliminates odor and has bactericidal effect.
Anti-drip
Automatic shut off
Anti-calc
IRONING TIPS
Owner's manual