Teesa TSA2011 Manuel D'utilisation page 23

Owner's manual
The spray can be used provided the water tank is filled with water.
Press the spray button to release spray.
NOTE: When using spray for the first time, the button has to be pressed repetitively to
activate this function.
Use this function for steam ironing. Set the steam ruler to required position:
0 Dry ironing
1 level Lowest level of continuous steam operation
st
ECO Optimum level of continuous steam operation
BOOST The most powerful continuous steam level. To use this setting, push the
ruler to BOOST position and hold it there. The function will be active as
long as you hold the ruler is this position.
Shot of steam gives extra steam to remove persistent wrinkles.
1. Move the temperature control at the "MAX" position and wait until the temperature light
goes off.
2. Press the steam shot button.
3. Wait few seconds for the steam to penetrate the fiber before pressing again.
NOTE:
• For the best steam quality, do not use more than three successive steam shots at a time
(keep the intervals between single shots).
• Excessive use of this feature will cause the iron to cool down.
• When using steam for the first time, the button has to be pressed repetitively to activate
this function.
• Before operating the shot of steam control make sure the temperature light is out.
WARNING:
• Do not apply steam near or on a person!
• Be careful, released steam is hot and may cause scalds. Do not iron garments while
wearing it.
Use the function on hanging fabric: hold the iron in vertical position and press the steam
shot button. Bring close the iron's soleplate to the fabric and move it slowly over the material.
Spray
Continuous steam control
Steam shot
Vertical steam
23
EN