Teesa TSA2011 Manuel D'utilisation page 22

22
1. Make sure the iron is unplugged.
2. Set the steam ruler to dry ironing (position "0").
3. Fill the tank through the water inlet. Do not overfill the tank above MAX level.
4. Use distilled water only; do not use chemically de-limed or perfumed water, as it may
damage the device. Do not pour any liquid other than water into the tank.
5. The water tank cover must be closed during operation.
Note: Do not store the iron with water in the tank!
1. If using with steam, fill the iron as described in the section "how to fill the water tank".
Steam ironing is only possible when highest temperatures are selected (otherwise,
water may escape through the soleplate).
2. Plug the device to power mains.
3. Turn temperature dial to your desired setting, which is depended on the fabric of
garment, and temperature indicator will illuminate while heating up. You can also refer
EN
to chart below. Once it reaches the temperature, the indicator will be extinguished,
which indicates the soleplate has achieved the selected temperature.
Caution:
• Do not touch hot soleplate at any time before cooling down!
• Don't emit the steam directly on people or animals!
Setting
Note: temperatures provided in this chart are for reference only, and may vary in your device
for various external reasons.
4. Set the steam ruler to required position and begin ironing.
5. Disconnect the iron from the mains supply when finished. Carefully pour off any
remaining water (risk of scalding) and leave the iron to cool off in vertical position.
Note: When the ironing is finished, and during breaks in ironing, place the iron in its upright
position.
OPERATION
How to fill the water tank
Ironing
Fabric
Nylon
Silk
Wool
Cotton
Linen
Owner's manual
Temperature Variable steam
60°C - 105°C
105°C - 145°C
145°C - 175°C
175°C - 200°C
200°C - 220°C
×
×
√
√
√