Luminance Brands Kathy Ireland Home ZEKE Manuel Du Propriétaire page 6

3. Ceiling Fan Assembly
3.3
Position the Light Fixture Adapter onto the Fan Motor
Assembly Hub .
NOTE: When positioning, it is critical to align the
four inside corners of the Light Fixture Adapter
to the four corners of the Fan Motor Assembly's
Upper Housing. If the Light Fixture Adapter Slots
do not align, rotate the Light Fixture Adapter
45 degrees, until it Aligns.
Align the Light Fixture Adapters Three Slots with the
Fan Motor Assembly's Three Holes (Figure 3) .
Reinstall the Three previously removed #6-32 x 3/8"
Pan Head Screws with Lockwashers into the Light
Fixture Adapters Slots and securely tighten all screws
(Figure 3) .
A spare #6-32 x 3/8" Pan Head Screw with Lockwasher
is supplied in the parts bag, if needed .
NOTE: The LED Light Fixture Assembly will be
installed during the Final Assembly, after the
Ceiling Fan is Hung and Wired.
3.4
Carefully turn the partially assembled Ceiling Fan right
side up and place the Fan securely into the packing
styrofoam . Careful not to bend the Blades .
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 6" Downrod (Figure 4) .
Remove the Pin from the 6" Downrod, then remove the
Hanger Ball (Figure 4) .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .11 .
NOTE: Do not loosen the Screw that attaches the
Green Ground Wire to the Hanger Ball.
(Continued)
REINSTALL THREE #6-32 x 3/8"
PAN HEAD SCREWS WITH
LOCKWASHERS
Figure 3
PIN
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 4
6
ALIGN THREE LIGHT FIXTURE
ADAPTER SLOTS WITH THE
THREE MOTOR HUB HOLES
LIGHT FIXTURE
ADAPTER
ALIGN FOUR LIGHT FIXTURE
ADAPTER INSIDE CORNERS
WITH THE FOUR UPPER FAN
MOTOR ASSEMBLY HOUSING
CORNERS
FAN MOTOR
ASSEMBLY
HOUSING
GREEN GROUND WIRE
6" DOWNROD
HANGER BALL
ETL Model No.: CF444