F Inner Lower Housing; G Shade Assembly - Luminance Brands Kathy Ireland Home ZEKE Manuel Du Propriétaire

6.5
Position the Inner Lower Housing onto the Light Fixture
Adapter, aligning the Four Screw Holes .
NOTE: Be sure the Red Dot on the Inner Lower
Housing aligns with the Red Dot on the Light
Fixture Adapter, as shown.
Install and tighten the Four #6-32 x 8 mm Flat Head
Screws (supplied) to complete the installation of the
Inner Lower Housing (Figure 30) .
A spare #6-32 x 8 mm Flat Head Screws is supplied in
parts bag, if needed .
6.6
Place the Shade Assembly's Four Key Hole Slots onto
the Four Inner Lower Housing Protruding Studs, as
shown in Figure 31 .
While gently pushing the Shade Assembly up onto the
Studs, rotate the Shade Assembly Clockwise to engage
the Four Key Hole Slots onto the Protruding Studs .
Position the Shade Assembly's Four Flat Sides aligned
with the Four Flat Sides of the Fan Motor Assembly
(Figure 31) .
NOTE: Periodically check that the Shade Assembly
is seated fully clockwise in the Inner Lower
Housing.
You have now completed the assembly of your new
Ceiling Fan .
Please call Customer Service at 1-800-777-4440
if you have any questions about installation and
operation of this Ceiling Fan .
INNER LOWER HOUSING
Figure 30
INNER LOWER
HOUSING FLAT
SIDES (4)
SHADE ASSEMBLY SHADE ASSEMBLY
FLAT SIDES (4)
INNER LOWER
HOUSING
PROTRUDING
STUDS (4)
Figure 31
Please contact 1-800-777-4440 for further assistance
19
RED DOTS
INSTALL FOUR #6-32 x 8 mm
FLAT HEAD SCREWS
SHADE ASSEMBLY
KEY HOLE SLOTS (4)
luminancebrands.com
ETL Model No.: CF444