Installing The Exhaust Duct - Klarstein ION BREEZE Mode D'emploi

EN
30
FAN mode
• Press the MODE button until the FAN indicator lights.
• Press the FAN button to set the desired speed.
Note: The temperature cannot be set in this mode.
AUTO RESTART Function
If the power supply to the unit is interrupted, the unit will restart in its last used mode
with the last settings after it has been switched back on. The compressor restarts after 4
minutes.
• Start AUTO RESTART manually: Press the sleep button 10 times within 5 seconds,
the buzzer sounds 4 times.
• Cancel AUTO RESTART: Press the sleep button 10 times within 5 seconds, the
buzzer will sound 2 times.

INSTALLING THE EXHAUST DUCT

Important installation instructions
• Before use, check the voltage on the device badge. Connect the device only to
sockets which correspond to the voltage of the device.
• Install the equipment according to national wiring regulations.
• The plug must be easily accessible at all times after installation.
• The unit must ONLY be installed by a qualified technician!
Installation accessories
Part Description
Adaptor A, Exhaust duct,
Adaptor B (flat mouth)
Window Slider Kit*
Type A Screws
Type B Screws
Security bracket
Type A foam seal (adhesive)
Pc.
1 Set
1
2
6
1
2