CAME ZT6 Mode D'emploi page 8

a
Function Selection
1 ON -Automatic closure activated; (1 OFF-deactivated)
2 ON -"Open-stop-close-stop" function with button (2-7) and transmitter (AF board inserted) activated;
2 OFF -"Open-close" function with button (2-7) and transmitter (AF card inserted) activated;
3 ON - "Only opening" function with transmitter (AF card inserted) activated; (3 OFF-deactivated)
4 ON -"Maintained Action" function (excludes the function of the transmitter) activated; (4 OFF-deactivated)
5 ON "Pre-fl ashing during opening/closing activated; (5 OFF-deactivated)
6 ON -Obstacle detection activated; (6 OFF-deactivated)
7 OFF -"Re-closing while opening" function (connect the safety device on clamps 2-C1) activated;
(7 ON-deactivated)
8 OFF/ 9 OFF -"Re-closing while opening" function (connect the safety device on clamps 2-CX) activated;
8 OFF/ 9 ON -"Partial stop" function (connect the safety device on clamps 2-CX) activated;
(if the devices on the 2-CX clamps are not used, set Dip 8 to ON)
10 OFF -Total stop" function (connect the button onto clamps 1-2) activated; (10 ON - deactivated)
11 OFF -"Slave" function deactivated (to activate in the event of coupled connection)
12 ON -"Partial opening" function (automatic closing is fi xed at 8 seconds) activated;
12 OFF -"Partial opening" function (automatic closing is adjusted with the trimmer, if on/inserted) activated;
13 ON -"Safety test" function to check the effi ciency of the photoelectric cells activated;
(13 OFF-deactivated)
14 OFF -"Master" function deactivated (to activate in the event of coupled connection);
15 - Not used, keep the dip switch in the "OFF" position
16 ON -"Courtesy light function activated"; (16 OFF-deactivated)
17 ON -"Lamp cycle" activated; (17 OFF-deactivated)
18 ON - Activates brake during closure- (CBX, CBXT).
19 - Not connected
20 - Not connected
8
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.