Initial Commissioning; Removing The Protective Film; Putting The Charging Cradle In Place; Connecting The Charging Cradle - Auerswald COMfortel M-530 Notice D'utilisation

Initial Commissioning

Initial Commissioning

Removing the protective film

The handset display is protected by a protective film. Remove the protective film!

Putting the charging cradle in place

The charging cradle is designed for use in enclosed, dry spaces with a
temperature range of +5 °C to +45 °C.
Place the charging cradle on a flat non-slip pad.
Normally, the device feet do not leave marks on the surface on which it is placed.
However, due to the very large number of different varnishes and polishes used
on furniture, it is possible that the device feet might leave marks on the surface
they touch.

Connecting the charging cradle

1. Connect the flat connector (A) on the end
of the wall-mounted power supply cable
(B) to the charging cradle (C).
2. Plug the wall-mounted power supply (B)
into the mains socket.
Disconnect the flat connector from the
charging cradle (C) again:
1. Disconnect the wall-mounted power
supply (B) from the mains.
2. Press the unlocking key (D).
3. Disconnect the flat connector (A).

Inserting the battery and closing the battery compartment cover

Warning: Using unapproved rechargeable batteries or normal batteries
can cause serious harm to health or damage to equipment, and also
functional faults or damage to the device. The casing of rechargeable
batteries can be destroyed, or rechargeable batteries can explode.
20
B
C
D
COMfortel M-530 - Instructions V01 04/2019
A