Cleaning The Mesh Filter; Product Storage & Use - brondell Swash DS725 Advanced Bidet Toilet Seat Manuel Du Propriétaire

CLEANING THE MESH FILTER

Cleaning intervals will differ depending on use and water quality.
It is recommended to check the filter at least once a year.
1. Turn off the water supply and hold the toilet's flush lever down
until all of the water has drained from the tank.
2. Unplug the Swash, remove the bidet from the toilet, and
disconnect the bidet hose. You may want to use a bucket to
catch any dripping water from the bidet hose.
3. Remove the Mesh Filter from the water inlet with a pair of
tweezers or needle-nosed pliers.
4. Clean the filter with a toothbrush while running under tap water
to effectively remove any foreign substances or build-up.
5. Replace the Mesh Filter and carefully check that it is installed
correctly. If improperly installed, it could result in the product
leaking water.
6. Reconnect the bidet hose and place the seat back on the toilet.
Plug the cord back in, and turn the water supply back on.
7. Press either the Rear or Front button on the remote control to
refill the Reservoir Tank with water.
PRODUCT STORAGE & USE
Short Term Non-Use
If the product will not be used for more than a few weeks, you can simply unplug it.
You may also consider shutting the water supply off at the wall for extra precaution.
Long Term Non-Use
If the product will not be used for an extended time (longer
than four months), you should unplug the unit, shut the water
supply off at the wall, remove the Swash from the toilet by
forcefully pulling the Swash away from the tank off of the
mounting plate. Remove the bidet hose drain the Hot Water
Heater. To drain the Hot Water Heater, remove the drain plug
and the back of the bidet seat by turning it counterclockwise
by 90 degrees towards "OPEN" and then pulling it out so that
any residual water drains out.
Step 3
23