Hoover airLift UH70210 Mode D'emploi page 17

Keep your Air Lift
6 7
Slide other end of
belt around end
of brushroll.
See us do it:
Hoover.com/video-instruction-guide
running properly: cleaning the brushroll:
™
8
With belt in place, Replace the bottom
slide brushroll into plate and reinstall the
nozzle making sure 6 screws as shown.
that the brushroll
end caps are in the
correct orientation.
CAUTION
!
To reduce the risk of injury from moving parts-
Unplug before servicing.
For additional maintenance required for belt or
brushroll please contact a HOOVER
provider at 1-800-944-9200.
Vacuum is equipped with an automatic
brushroll shut-off in event of overload or jam.
Check for obstructions in the brushroll area and
remove any obstructions.
IMPORTANT:
Rotate brushroll manually to make sure the
belt is properly installed.
LUBRICATION NOT REQUIRED
The motor and brushroll are equipped with
bearings which contain sufficient lubrication for
their lifetime. The addition of lubricant could cause
damage. Do not add lubricant to
motor or brushroll.
Any other servicing should be done by an
authorized service representative. If appliance is not
working as it should, has been dropped, damaged,
left outdoors, or dropped into water, take it to a
service center prior to continuing use.
!
service
®
14