Hoover airLift UH70210 Mode D'emploi page 5

• Do not pick up anything that is burning or smoking, such as ciga-
rettes, matches, or hot ashes.
• Do not use without Dirt Cup and/or Filters in place.
• Unplug before connecting Air-Powered Hand Tool or Motorized
hand tool.
• The hose contains electrical wires. Avoid picking up sharp
objects. If hose appears damaged, cut, punctured or wires are ex-
posed, unplug unit and discontinue use. Do not attempt to repair
damaged hose, take to an authorized service center for repair (on
select models only).
• Always turn off this appliance before connecting or disconnecting
hose.
CAUTION:
TO REDUCE THE RISK OF DAMAGE:
• Avoid picking up hard, sharp objects with this product, as they
may cause damage.
• Do not use sharp objects to clean out hose as they can cause
damage.
• Store appropriately indoors in a dry place. Do not expose ma-
chine to freezing temperatures.
• With brushroll on, do not allow vacuum to sit in one location for
an extended period of time, as damage to floor can result.
WARNING:
This product contains chemicals
known to the State of California to cause cancer, birth defects or
reproductive hard. WASH HANDS AFTER HANDLING.
WARNING:
ELECTRIC SHOCK, THIS APPLIANCE HAS A POLARIZED
PLUG (ONE BLADE IS WIDER THAN THE OTHER). THIS
PLUG WILL FIT IN A POLARIZED OUTLET ONLY ONE
WAY. IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET,
REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A
QUALIFIED ELECTRICIAN TO INSTALL THE PROPER OUTLET.
DO NOT CHANGE THE PLUG IN ANY WAY.
NOTICE:
A Thermal Protector has been designed into your cleaner to
protect it from overheating. When the thermal protector activates
the cleaner will stop running. If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Empty the dirt cup.
3. Inspect the nozzle inlet, hose connector, hose, dirt cup inlet,
cyclonic filter, washable filter, and HEPA filter for any
obstructions. Clear obstructions if present.
4. When cleaner is unplugged and motor cools off for 30
minutes, the thermal protector will deactivate and cleaning may
continue.
If the thermal protector continues to activate after following the
above steps, your cleaner needs servicing.
TO REDUCE THE RISK OF
2