Brandt BFC584YNW-YNX Manuel D'instructions page 43

Troubleshooting
A layer of frost occurs in the
compartment
Temperature inside is too
warm
Temperature inside is too
cold
Doors cannot be closed
easily
Water drips on the floor
The light is not working
Check that the air outlets are not blocked by food and
ensure food is placed within the appliance to allow
sufficient ventilation. Ensure that door is fully closed.
To remove the frost, please refer to cleaning and care
chapter.
You may have left the doors open too long or too
frequently; or the doors are kept open by some
obstacle; or the appliance is located with insufficient
clearance at the sides, back and top
Increase the temperature by following the
«Display controls" chapter.
Check whether the top of the refrigerator is tilted back
by
10-15mm to allow the doors to self close, or if
something inside is preventing the doors from
closing.
The water pan (located at the rear bottom of the
cabinet) may not be properly leveled, or the draining
spout (located underneath the top of the compressor
depot) may not be properly positioned to direct water
into this pan, or the water spout is blocked. You may
need to pull the refrigerator away from the wall to
check the pan and spout.
• The LED light may be damaged. Refer to replace
LED lights in cleaning and care chapter.
• The control system has disabled the lights due to
the door being kept open for too long. Close and
reopens the door to reactivate the lights.
21