Brandt BFC584YNW-YNX Manuel D'instructions page 34

Installing your new appliance
Connect electrical connector
16.
accordance with step 3 and then install
part (which is in the plastic bag).
②
Upper hinge cover (left)
Reverse part by 180°and install it
①
17.
onto the right corner of upper door,
then mount part . (both of which are
②
taken down in step 2)
Take the reed switch out of the coping
18.
block(part 6 in step 3) and mount it
③
on another block for use (marked "R"
in the plastic bag). Place the removed
coping block back into the plastic bag.
Note: Be sure character side of reed
switch fits well with coping block.
19. Install part
①
② , and then install part
20. Open the upper door, mount door racks
and then close it.
in
①
12
connect the wire connector
③ .