Brandt BFC584YNW-YNX Manuel D'instructions page 33

Installing your new appliance
Handle covers
Door holder
Special self-tapping screws
Stop block
Handle
Self-tapping screws
Screw hole covers
Change screw hole covers on middle
8.
cover plate from left to right (as shown
in figure below).
Place refrigerator flatwise, remove part
9.
and then loose screws
③
part and part .
② ①
washer
Lower honge part (right)
Note : washer may
Front foot fixed board
stick to lower door
Adjustable bottom feet part
Self-tapping screw
Unscrew the lower hinge, change it to
10.
the near hole site, and then screw up
and mount the washer.
Repeat the step 9, change part
11.
and part to right and then fix them
②
with screws . Finally install part
④
Lower hinge part left
Move the lower door and adjust its
12.
position to align lower hole site and
upper hinge axis. Turn the middle
hinge by 180, change the washer on
the axis to the upper side, adjust the
middle hinge to the appropriate
position and then install it.
Note: washer may stick to
lower door
Unscrew the upper hinge axis, turn
13.
the upper hinge over and fix axis on
it. Then place it at side for use.
. Remove
④
Exchange wires both in the left and
14.
right slots of refrigerator body
Move the upper door to appropriate
15.
position, adjust part
door, Move the connecting wire
the slot of upper door from right to
left, and then fix part
to left
①
with screws
.
③
(Please hold upper door by hand
when installing)
11
washer
and upper
①
in
②
and wire
① ②
.
③