Brandt BFC584YNW-YNX Manuel D'instructions page 31

Installing your new appliance
It may not work properly if left at a
temperature above or below the indicated
range for a long period of time.
Climate Ambient
SN +10°C to +32°C
class temperature
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
Place your appliance in a dry place
•
to avoid high moisture.
Keep the appliance out of direct
•
sunlight, rain or frost. Keep the
appliance away from heat sources
such as stoves, fires or heaters.
Leveling of appliance
• For the appliance to be sufficiently
leveled, and the air to circulate
correctly in the lower rear section
of the appliance, the bottom feet
may need to be adjusted. You can
adjust them manually by hand or
by using a suitable spanner.
• To allow the
doors to self-
close, tilt the
top backwards
by about
10mm.
Installing the door handles
For the convenience of transportation, the
door handles are separately provided in a
plastic bag, you can install the door
handles as follows.
Lever screw covers on the left side of
1.
the door, and then put them back to the
plastic bag.
Match the handle on the left side of
2.
the door, keeping axes of screw holes in
the handle and the door in a line, as
shown in the following picture.
Fix the handle with the special screws
3.
provided in the plastic bag. And then
install the handle covers.
Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied)
to the left side, if the installation site
requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need:
Cross shaped screwdriver
8mm socket wrench
Thin-blade screwdriver
Note: Before you start, lay the refrigerator
on its back in order to gain access to the
base. You should rest it on soft foam
packaging or similar material to avoid
damaging the backboard
refrigerator. To reverse the door, the
following steps
recommended.
Stand the refrigerator upright. Open
1.
the upper door to take out all door racks
(to avoid damaging the rack) and then
close the door.
9
8mm socket wrench
8mm wrench
screwdriver
of the
are generally