Clarity Alto Mode D'emploi page 15

Programming/Editing Memory Dial Buttons
This feature allows you to program or edit numbers in the ten memory locations or
make changes to the currently programmed numbers .
To program the memory keys:
1 . Press and hold the desired memory location (for example, M10) to store the number .
The phone will beep and the keypad will start blinking to confirm you are in memory
programming mode . (See Figure 9)
2 . Enter the telephone number you wish to store (up to 31 digits) . If no button is pressed
within 30 seconds, the phone will time out and go back to idle or talk mode .
3 . Press and release the same memory button (M10) again . You will hear three beeps,
the keypad will stop blinking and your memory button is now programmed with the
phone number you entered during the previous step .
To edit the memory keys: repeat the programming sequence again .
NOTE: programming a location overwrites the previously saved number at that loca-
tion .
To dial the saved numbers:
1 . Handset mode, lift the handset and press the appropriate memory button .
2 . Speakerphone mode, press the appropriate memory button with the handset in the
cradle .
During Talk Mode
While on a call, the 2-digit display will show the volume level; if you wish to see the cur-
rent tone setting, press TONE button briefly during a call .
OPERATIONS
Figure 9
15