Function Buttons - Danby DPA100E1BDB Mode D'emploi

Function Buttons

2
6
4
8
5
1. TEMP DOWN Button: Push this button to decrease the
indoor temperature setting by 1°C (1°F) increments to 18°C
(64°F).
3
2. TEMP UP Button: Push this button to increase the
indoor temperature setting by 1°C (1°F) increments to 32°C
(90°F).
3. M (Mode) Button: Each time the button is pressed, the op-
eration mode changes in the following sequence:
1
COOL
4. Button: Used to stop or start louver movement and
7
move the airfl ow direction up/down as desired.
5. Button: Unit operation starts when this button is
pressed and stops when the button is pressed again.
6. Button: Used to select the fan speed in 3 steps:
Maximum
Medium
9
Low
7. Button: Start Up Time: Press this button to activate the
Auto-on time setting. Each time it's pressed will increase
the start up time. To cancel the Start up time setting, just
press the timer button again. Start Down Time : Press the
timer button to activate the start down setting. Each time it is
pressed, increases the start down time. To cancel the start
down setting, press the timer button again.
Button: Select this function if you want the unit to
8.
maintain a comfortable setting and save energy while you
sleep. This function is available on COOL mode only.
Button: Press this button to change from °C to °F.
9.
• With the unit in stand-by, press the "M" button for 20 sec-
onds to change from °C to °F.
• To change the unit from °C to °F, press the ▲
tons simultaneously.
DRY
4
FAN
▲ and ▼ but-