hestan Aspire Serie Manuel D'installation page 39

TESTING AND INITIAL START-UP
INITIAL STARTUP INITIAL STARTUP
Once the appliance is plugged in, the display will show the Hestan logo, a brief info screen,
then go dark.
Turn the appliance ON by pressing the Power
show a Hestan logo, then the message "Initial test, please wait..." for 2-3 minutes. After this
phase the compressors will start up and remain on until the default temperature (set at the
factory) is reached. Allow ample time for the refrigerator to reach this temperature before
loading any items (6-12 hrs). During this time, deactivate any error messages by pressing the
Alarm button.
Ice Maker Ice Maker
If the appliance is provided with an ice maker, make sure that the water filter cartridge
is properly installed, and the appliance is connected to the water source. Follow these
instructions for cleaning / purging the water system for the first time. Place a small tray or
bowl inside the ice bin, under the ice maker tray to catch any water during the purge cycle.
Functions
42
+
°F
Settings
1
-
°F
Ice Maker
Water Filter
Water System
Purge
Manual Clean
Yes No
Cleaning started
Please wait...
button for three seconds. The display will
42
+
°F
1
-
°F
At the Home
screen, touch the
Functions icon.
Scroll left, then
touch the Water
System Purge icon.
Touch YES to
activate the
manual cleaning.
Replace ice bin and press OK
Please wait...
(CONT.)
Functions
Settings
Manual Clean
Start Cleaning
Enter
Manual Clean
Cleaning running
Manual Clean
Empty water from ice bin
OK
Cleaning completed
Please wait...
© 2021 Hestan Commercial Corporation
Touch the Enter
icon to start the
cleaning.
Cleaning running...
At the end of the
cleaning, empty
water from ice bin,
then press OK.
Wait a few
seconds, the home
screen will appear.
Remove the tray or
bowl.
37
EN