This heater is protected with an overheat protection that switches off the appliance automatically
in case of overheating. For example: due to the total or partial obstruction of the vents. In this
case, unplug the appliance, wait about 30 seconds for it to cool and remove the object which is
obstructing the vents. Then switch it back on as described above. The appliance should now
operate normally. If the problem persist, please contact Customer Service for assistance.
CLEANING & MAINTENANCE
•
Before undertaking any cleaning or maintenance on the appliance, disconnect it from the
power supply.
•
For cleaning it is recommended to use a soft moist rag and neutral detergent. Do not use an
abrasive cloth or devices which could affect the appearance of the appliance. Check that the
hot air outlet and the ventilation inlet are free of dust and dirt.
During cleaning, be careful not to touch the heating elements.
•
To open the filter on the back for cleaning, press the top of plastic net at back.
•
In case of breakdown and/or poor functioning of the appliance, disconnect the appliance
from the power supply and contact an authorised repairer.
NOTE: As a result of continual improvements, the design and specifications of the product within
may differ slightly to the unit illustrated on the packaging.
GUARANTEE
Refer to the enclosed guarantee conditions for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need replacement after extended use, do not put it
in the domestic waste but dispose of it in an environmentally safe way.
BATTERIES
Unwanted batteries should be disposed of in an environmentally friendly way and
Discharge the battery by letting the machine run at no load speed until the
Hand in the machine as chemical waste with the recycling station in your
in conformance with the local regulations.
WARM TECH
81, rue de gozée
6110 Montigny-le-Tilleul
Belgique
Tél : 0032 (0) 71 29 70 70 Fax : 0032 (0) 71 29 70 86
2021
motor stops.
municipality.
26