Télécharger Imprimer la page

Warm Tech WTCHM2002TL Traduction Des Instructions D'origine page 22

Publicité

Les langues disponibles

Les langues disponibles

1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in your
area matches that on the rating label on the unit.
2. Carefully remove the heater from the plastic bag and the carton.
3. Place the heater on the wall ,setting the master button to "-"position.plug the cord set into a
AC220-240V~ electrical outlet,with "BEE" sounds the "Power"light is on with RED color and
the heater will shows the default temperature ,it will twinkle 3 seconds.
1)General Using OPERATION
1.
Turn the heater ON by pressing remote control the ON/OFF button ,the unit will blow the
air and "
" light is on.
2.
Pressing the "MODE" button on remote control ,the unit will blow the warm air and
both"
"and"
Pressing the "MODE" button second times on remote control,the unit will blow the hot air and
both "
""
3.
Pressing the "MODE" button Three times on remote control,the unit will blow the cold air
and "Fan/M" light is on.
PS:For smart operate,customer only press the one start button near about
master button,the heater will working with hot air and both "
on.
Smart button view:
Master Button
One start Button
Button
2) 24H Timer FUNCTION
1.Open the appliance as working conditions,(fan,warm,hot are all ok).This function
through by Remote control "
2.
Press "
" button ,set the timer up to 24 hours,keep press "
00:00--24:00(01:00=1hour,...24:=24:00 hours ect.) and the "
from
PS:set as "00" means no set timer ,the "
3)THERMOSTAT INSTRUCTIONS
1. Open the appliance as working conditions,(fan,warm,hot are all ok).This function
only through by Remote control.
2. To adjust temperature, press the "
temperature set from 10℃ to 49℃.
3. When the air temperature drops 2 degree below the set temperature, the heater
will start heating with "
" lights are on.
" lights are on.
" button .
"(2000W).
" button to increase the hours
" light is off.
" to set the desired temperature and the
""
"lights are
" light is on.
22

Publicité

loading