Example Of Auto Operating Mode - Kübler CODIX 533 Mode D'emploi

6. The device is now ready for
operation. Press the right key to start it and the left
key to stop it.
Note:
After powering, the device outputs 0.00 mA or 0.00
V. The Auto function does not start automatically.
Alter the manual start of the Auto function, the device
outputs the value ou.1. After the execution of the
cycle, the output remains with the value ou.1.
4.2.3.1 The
in Auto Operating Mode
1. If YES was selected for
can show a value different from the value of the
output setpoint.
2.The SPecial disPlay function
A
– The function SPecial.decimalPoint
allows defining the number of decimal places (only
for the values appearing on the display).
– display.Low allows defining the mini-
mum value to be displayed.
– display.High allows defining the maxi-
mum value to be displayed.
SPecial disPlay Function
, the display
to
to
3. Press both keys to resume programming at point
4.2.3 (1), SiGn see
⇑ ⇑
4. When outputting the setpoint in Auto mode, when
the SPecial disPlay function is activated, the
whole current or voltage ranges are used.
I.e. the setpoint ranges 0 ... 24 mA and 0 ... 12 V
relate respectively to the scaled values.
If e.g. the value 5 is set for di.Lo and the value 10 is
set for di.Hi, the current output will be set as follows:
di.Lo 5 corresponds to 0 mA,
di.Hi 10 corresponds to 24 mA.
The scaled values must be used when inputting the
reference points (ou.1, ou.2, ...). If the reference
point ou.1 is to output 12 mA (in the above exam-
ple), you must input 7.5 and not 12 mA.

4.2.4 Example of Auto Operating Mode

Without Special display function
8 V
PE. 4
ou. 4
3 V
2 V
10 s 20 s 30 s 40 s 50 s
A
in the flow chart
PE. 5
ou. 5
9