M-E cuveo CT-W2 Mode D'emploi page 14

EN
DIMMING FUNCTION
Attention! This function is only available
for dimmable Cuveo receivers. Once the
receiver is switched on, i.e. the device
(lamp) is powered on, pressing the "ON"
button can activate the dimming
function. Pressing the "ON" button a
second time switches off the dimming
function and the brightness of the lamp
will continue to remain at that level.
BATTERY CHANGE
Carefully lift the front panel of the wireless
wall switch (e.g. using a flat-head
screwdriver as a lever) and set it aside.
Remove the old battery and dispose of it
properly. Place one 3 V (type: CR2477)
battery with correct polarity into the battery
compartment of the wireless wall switch.
Secure the front panel back to the wireless
wall switch.
14
SERVICING AND CLEANING
Servicing or repair works can only be
performed by a qualified person or at
a special service centre. There are no
components in the product that need
to be serviced. At no point must it be
opened or disassembled given the
danger of electric shock.
• The external surface can be cleaned by
using a dry, soft and clean cloth. Do not
press too hard on the front panel or on
the casing, as this can leave scratch
marks on the surface.
• Dust can be easily removed by using a
soft and clean brush with long hairs and
bristles and a vacuum cleaner. In no
event must an aggressive cleaning agent
or other chemical solutions be used since
that can affect the casing or impair its
proper functioning.