M-E cuveo CT-W2 Mode D'emploi page 13

INITIAL OPERATION
Configuring the wireless
wall switch for a Cuveo
receiver
a) Switch the Cuveo receiver to the learning
mode (see the instruction manual of the
respective Cuveo receiver). A flashing LED
on the receiver indicates the switch.
b) Before the LED on the receiver stops
flashing, press the "ON" button of the
desired switch channel on the wall switch
for which the Cuveo receiver is being
configured. The red LED on the receiver
continues to flash. This indicates that
the process of configuration has been
successfully completed.
c.) Please repeat these steps for other
wireless transmitters.
Deleting the wireless wall
switch on a Cuveo receiver
For this, please follow the instructions
contained in the instruction manual of
the Cuveo receiver.
FUNCTION TEST /
OPERATION
Connect a device to the configured Cuveo
receiver. Please read the chapter titled
"Technical Details" of the respective Cuveo
receiver to find information on the maxi-
mum capacity permitted for this device.
SWITCH FUNCTION
Operating the corresponding "ON" or
"OFF" button of the switch channel on
the wireless wall switch will cause the
Cuveo receiver to be switched on (LED on
the receiver will flash) or off (LED on the
receiver will go out).
EN
13