Publicité
Les langues disponibles
Les langues disponibles
EN
function and the brightness of the lamp
will continue to remain at that level.
BATTERY CHANGE
Carefully lift the front panel of the wireless
wall switch (e.g. using a flat-head
screwdriver as a lever) and set it aside.
Remove the old battery and dispose of it
properly. Place one 3 V (type: CR2477)
battery with correct polarity into the battery
compartment of the wireless wall switch.
Secure the front panel back to the wireless
wall switch.
SERVICING AND CLEANING
Servicing or repair works can only be
performed by a qualified person or at
a special service centre. There are no
components in the product that need
to be serviced. At no point must it be
opened or disassembled given the
danger of electric shock.
14
•
The external surface can be cleaned by
using a dry, soft and clean cloth. Do not
press too hard on the front panel or on the
casing, as this can leave scratch marks on
the surface.
•
Dust can be easily removed by using a soft
and clean brush with long hairs and bristles
and a vacuum cleaner. In no event must an
aggressive cleaning agent or other chemical
solutions be used since that can affect the
casing or impair its proper functioning.
DISPOSAL
Dispose of the product at the end of its
lifespan in compliance with the valid
statutory provisions. Dispose of the batteries
in a proper manner at sites specially
designated for that purpose. As end
consumer, you are required under law
(Battery Act) to return all used and
rechargeable batteries; their disposal via
domestic waste is not permitted.
Publicité
