M-E cuveo CT-W1 Mode D'emploi page 13

a) Switch the Cuveo receiver to the learning
mode (see the instruction manual of the
respective Cuveo receiver). A flashing LED
on the receiver indicates the switch.
b) Before the LED on the receiver stops
flashing, press the "ON" button of the
desired switch channel on the wall switch
for which the Cuveo receiver is being
configured. The red LED on the receiver
continues to flash. This indicates that
the process of configuration has been
successfully completed.
c.) Please repeat these steps for other
wireless transmitters.
Deleting the wireless wall
switch on a Cuveo receiver
For this, please follow the instructions
contained in the instruction manual of
the Cuveo receiver.
FUNCTION TEST/OPERATION
Connect a device to the configured Cuveo
receiver. Please read the chapter titled
"Technical Details" of the respective Cuveo
receiver to find information on the
maximum capacity permitted for this device.
SWITCH FUNCTION
Operating the corresponding "ON" or "OFF"
button of the switch channel on the wireless
wall switch will cause the Cuveo receiver
to be switched on (LED on the receiver will
flash) or off (LED on the receiver will go out).
DIMMING FUNCTION
Attention! This function is only available
for dimmable Cuveo receivers. Once the
receiver is switched on, i.e. the device
(lamp) is powered on, pressing the
"ON" button can activate the dimming
function. Pressing the "ON" button a
second time switches off the dimming
EN
13