Key Components Parts List; Operating Conditions - Stiebel Eltron Scale TAC-ler Série Manuel D'utilisation Et Installation

SPECIAL INFORMATION
2.1

Key components parts list

1 Housing cap
2 Fitting w/ shut-off valve [x2]
3 Pressure relief button [x1]
4 Mounting bracket [x1]
5 O-ring [x1]
6 Housing sump [x1]
7 Small parts bag (not shown), containing:
Mounting bracket lag bolts [x4]
Pan-head screws [x4]
Washers [x8]
3.

Operating conditions

The following list provides guidance on the conditions required
for successful operation of your Scale TAC-ler system. Use of this
equipment outside of these operating conditions may adversely
affect the performance of your system, damage the TAC media,
result in system damage including water leaks and resulting prop-
erty damage, and may void your warranty.
It is very important to note that the presence of elevated levels
of chlorine, iron, manganese, hydrogen sulfide, copper, and cer-
tain other contaminants can damage the TAC media, reducing
its effectiveness and shortening its life. Water exceeding any of
the following levels should be pre-treated to reduce contaminant
levels below the stated level:
Optimal hardness level for treatment
Max. treatable hardness level
pH range
Chlorine max.
Hydrogen peroxide max.
Iron max.
Manganese max.
Copper max.
Max. water temperature
Recommended pressure range
Hydrogen sulfide (H S), polyphosphates, and oils must be removed.
2
Do not allow TAC media or the water in your Scale TAC-ler system to freeze.
www.stiebel-eltron-usa.com
Scale TAC-ler
0.4-1.8 gpg (7-30 mg/l)
75 gpg (1,283 mg/l)
6.5 to 8.5
3 ppm (3 mg/l)
0.5 ppm (0.5 mg/l)
0.3 ppm (0.3 mg/l)
0.05 ppm (0.05 mg/l)
1.3 ppm (1.3 mg/l)
110°F (43°C)
15 to 80 psi (1 to 5.3 bar)
MATERIAL LOSSES:
Confirm that your water conditions meet the operating
conditions above before commencing the installation
process. If in doubt, call your dealer for advice.
Scale TAC-ler | 3