Télécharger Imprimer la page

Knick BasicLine BL 570 Mode D'emploi page 18

Publicité

Les langues disponibles

Les langues disponibles

3.
Configuration
3.1 Tools
A screwdriver with a width of 2.5 mm is required to open the unit
and to connect the wires to the screw clamp terminals.
3.2 Opening the unit
Disengage the top part of the housing
on both sides using a screwdriver.
Pull out the top part of the housing and
the electronics section until they lock.
3.3 Adjustment
Adjust the input and output ranges and
the offset using DIP switches S1, S2 and
S3 as indicated in the following tables.
When selecting a variable gain or offset
setting, additional adjustments can be
made using the Span (gain) or Zero (offset)
potentiometers accessed from the front.
Caution!
Only use a screwdriver which is
properly insulated against the
voltage applied to the input when fine
adjusting the potentiometers on the
front.
18
BL 570

Publicité

loading