Fein GRIT GKS75-1,5KW Notice D'instruction D'origine page 11

Adjusting the belt tracking.
Switch the machine on only briefly
and check the belt tracking.
If the grinding belt moves left or right,
adjust the belt tracking with the star-
knob bolt (8) until centred.
If the belt tracking cannot be adjusted centred:
Clean the drive wheel (13) and the contact wheel (12)
with compressed air.
Check the drive wheel and the contact wheel for wear,
deformation and damage. Have damaged components
replaced without delay!
Replacing the grinding belt.
Before any work on the machine itself, pull the
mains plug.
Loosen screw (14) and open the side cover (15).
Push belt tension pedal (6) down to
release the clamping device.
Remove the old grinding belt.
Before attaching the new grinding belt,
observe the information concerning
the running direction on the inner side
of the grinding belt! It must correspond with the running
direction of the drive wheel.
Place the grinding belt both around the drive wheel (13)
and around the contact wheel (12).
Push the belt tension pedal (6) up again
to tension the grinding belt.
Shut the side cover (15) and tighten
screw (14) again.
Switch the machine on and adjust the
belt run.
Operating instructions.
Switching on and off.
Switching on:
Release the safety pushbutton (7) and lift it up. Press the
"I" button (11).
Switching off:
Lift up the safety pushbutton (7). Press the "0" (11) but-
ton.
After switching off, the machine runs on for
approx. 50 seconds.
Safety pushbutton:
In emergency situations, press the red safety pushbutton
to switch the machine off.
Overload protection.
In case of continuous high load over a longer period of
time, the machine is switched off. After a cooling-down
period of approx. 15 minutes, the machine is ready for
operation again.
Contact grinding (figures 3+4).
Check if the star-knob bolt (5) is firmly tightened.
Check the gap size of the grinding rest.
Check if the spark guard (1) is properly adjusted and
tightened.
Switch the machine on and check the belt run.
Place the workpiece firmly onto the grinding rest.
Guide the workpiece with both hands or fasten it in a fix-
ture.
Extraction device
The machine can be connected via sleeve (16) to an
exhauster.
Repair and customer service.
Repairs may be carried out only by qualified per-
sons in conformity with the valid regulations.
For repairs, we recommend our FEIN customer service
centre, the FEIN authorised service centres and FEIN
agencies.
The current spare parts list for this power tool can be
found in the Internet at www.fein.com.
Carry out the following maintenance regularly:
Blow out the ventilation slots (10) at the motor
housing and the marked locations with compressed
air (see Instruction label (17)).
Lubricate the machine daily (when in use) with
machine oil at the locations marked (see Instruc-
tion label (17)).
Check the drive wheel and the contact wheel for wear
and damage each time when changing the grinding belt.
Have damaged parts replaced.
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's guarantee. For further
details on this, please contact your specialist dealer, your
national FEIN representative, or the FEIN customer serv-
ice centre.
Declaration of conformity.
GRIT declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Original language English/German
Environmental protection, disposal.
Stationary machines should be sorted for environment-
friendly recycling in accordance with national laws.
en
11