Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT INSTALLATION INSTRUCTIONS (CONT.)
FOR INSTALLING AQUA-PURE TASTE/ODOR FILTER UNDER KITCHEN SINK
ON COLD WATER LINE
Tools and Parts Required
(not included):
1) 3/4" x M ST Adapter Wrought
2) SW Elbow
3) PTFE Tape
4) Tube Cutter
5) 3/4" SW Gate Valve
6) 3 Ft. (0.9 M) Piece of 3/4" Copper Tubing
Identify all parts as shown in diagram. Read all instructions
carefully before attempting to start installation.
Step 1: Cut out approximately 8" (20
cm) section of pip starting 12" (30.5
cm) for 1 high units and 22" (56 cm)
for 2 high units off the floor.
Step 4: Cover threads of both adapters
with PTFE tape and screw one adapter
into "IN" side of filter.
Step 7: Sweat elbow to tube connected
to "right" adapter.
1
2
Step 2: Sweat SW gate valve onto
water line. Sweat SW elbow onto
piece of copper tubing and sweat tub-
ing to valve.
Step 5: Mount filter bracket to wall or
suitable support.
Step 8: Loose fit "A" elbow to water line
coming down from sink. Measure "B"
and cut tubing to go across filter. Loose
fit "C" elbow at end of tubing. Measure
"D" and cut tubing to fit to elbow sweat-
ed to"right" adapter on filter.
4
3
5
6
Step 3: Sweat SW elbow to one
adapter using piece of copper
tubing.
Step 6: Screw remaining adapter into
"OUT" side of filter, then sweat a piece
of tubing to the adapter.
Step 9: Now proceed to sweat remain-
ing fitting.
Publicité
