Align Doors (If Needed) - Midea MRQ22D7AST Guide De L'utilisateur

FLUSH THE WATER SYSTEM
After installing the replacement water filter it is important to flush air from
the water line so that water will not drip from the water dispenser.
1.
Turn on the main water supply.
2.
Dispense 2.5 gallons of water (flush for approximately 5 minutes) to
remove trapped air and contaminants from the system.
NOTE: Do not dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of 30 seconds ON
and 60 seconds OFF. In some homes, additional flushing may be
required.
3.
Open the refrigerator door to make sure there are no water leaks
coming from the water filter.

ALIGN DOORS (IF NEEDED)

If the top edges of the refrigerator doors are not aligned, adjust the height
of the lower door.
1.
Raise the lower door so that the top edge is level with the higher door.
2.
Using pliers, insert a snap ring (provided) into the gap between the
hinge-grommet and the lower door hinge.
NOTE: The number of snap rings used will depend on the size of the
gap.
a
22
a
Snap ring
b
Door hinge
b