Meaning Of The Error Codes; Troubleshooting - Philips Saeco PICOBARISTO HD8927 Mode D'emploi

English
24

Meaning of the error codes

Error code Problem
01 The coffee grinder is
blocked
03 - 04 There is a problem
with the brew group.
05 There is a water
circuit problem.
14 The machine is
overheated.

Troubleshooting

Problem
The machine does not
switch on.
Below you find a list of the error codes that may appear on the display, their
meaning and how to solve the problem. If these solutions do not help to
remove the error code from the display and bring the machine back to
normal working order, contact the Saeco hotline. Contact details can be
found in the warranty booklet or on
Cause
The coffee exit duct is
clogged.
The brew group is
dirty.
The brew group is not
positioned correctly.
There is air in the
water circuit.
This can have several
causes.
This chapter summarizes the most common problems you could encounter
with the machine. If you are unable to solve the problem with the
information below, visit www.saeco.com/care for a list of frequently asked
questions or contact the Consumer Care Center in your country.
Cause
The machine is disconnected
or the main switch is in the 'off'
position (0).
www.saeco.com/care
Possible solution
Clean the coffee exit duct thoroughly
with the handle of the measuring
spoon or a spoon handle. Switch the
appliance off and on again.
Remove the brew group and clean it
thoroughly (see 'Cleaning the brew
group').
Remove the brew group and reinsert
it. Make sure the two reference signs
on the side match before you slide
the brew group back into the
machine.
Remove and place back the water
tank a couple of times. Make sure
you insert it into the machine
properly. Check if the water tank
compartment is clean.
If you use an AquaClean filter:
remove the AquaClean filter from the
water tank and shake it to remove all
air from the filter. Then place the
AquaClean filter back into the water
tank.
Switch the machine off and switch it
back on again after 30 minutes. Try
this 2 or 3 times.
Solution
Check if the mains cord is inserted
correctly.
.