Tripp-Lite U442-DOCK2-S Manuel De L'utilisateur page 5

Installation
Notes:
• Only one monitor can be connected at a time.
• Only one memory card slot can be used at a time.
• When connected to power through the USB-C PD charging port, 15W is dedicated
to the docking station and connected USB peripherals. Remaining power is used to
charge the connected USB-C device.
• See Optional Accessories section for suggested cables.
• When the unit is connected to the USB-C port on your computer and to a network
via Cat5e/6 cabling, a network connection will be automatically established. If no
connection is made, you can manually establish one by going to your computer's
network settings page. For example, on a Mac, you would navigate to the Network
section found in System Preferences, click the "Assist Me" button to get to the
Network Setup Assistant, then follow the prompts to establish a connection.
• When plugging and unplugging the PD adapter, connected USB devices will
disconnect and then reconnect quickly. To prevent possible data loss or corruption,
avoid disconnecting the PD adapter from the AC power supply while transferring data.
1. Connect USB-C port to USB-C or Thunderbolt 3 port on your laptop,
tablet or other device.
2. Connect VGA port to VGA port on a monitor using a VGA cable.
OR
3. Connect HDMI port to HDMI port on a monitor using an HDMI cable.
OR
4. Connect mDP port to mDP port on a monitor using a Mini DisplayPort
cable.
5. Connect USB 3.0 hub ports to USB peripherals.
6. Connect RJ45 port to Ethernet network using UTP cable.
7. Connect 3.5 mm mini stereo port to microphone or speaker using
3.5 mm audio cable.
8. Insert Micro SD or SD/MMC card into corresponding memory card slot to
access external memory.
9. Charge device by connecting its USB-C charger to adapter's USB-C PD
charging port.
11-022-93379C.indb 5
5
12/11/2017 10:21:24 A