Connecting Accessories - MSW Motor technics GD2580-S Manuel D'utilisation

ERROR CODES
The display may show the following error codes:
"1.": faulty adjustment (setting) of garage door movement.
"2.": obstacle during garage door opening.
"3.": obstacle during garage door closing.
"4.": photocell covered or faulty.
"5.": error in learning or coding the remote controller.
"6.": operating time exceeded 100 seconds.
"7.": speed sensor damaged.
"8.": DC motor is faulty.

CONNECTING ACCESSORIES

SW-WALL – CONNECTION OF THE WALL SWITCH
PHOTO – CONNECTION OF THE PHOTOCELL
AL-IN + AL-SPK – CONNECTION OF THE ALARM
CONNECTION OF BACKUP POWER SUPPLY BATTERY (DC24V; the battery is
charged by the power supply of the drive):
13. REPAIRING AND MAINTENANCE
„GD2521-8, GD2375, GD3000, GD2500-I garage doors only"
Open and close the door manually once a month to check the balance system and if no
smooth moves occurs. Please contact qualified maintenance staff to repair any problem
immediately.
90
14. TROUBLESHOOTING
Problem
Loudness of the door
when moving
The doors are slanting as
it moves
The opener is not
working, LEDs are off
The opener is not
working, Door does not
fully close or open; LED
displays E1
Door stops before it is
fully up on opening cycle;
or Door auto-reverses
before reaching the
ground on closing; LED
displays E2
The door can't run to the
closing direction; LED
display E3
Push button operates
normally, remote control
is not working
The remote distance
became very near
distinctly, the brightness
of indicator lamps
became lower distinctly
Rev. 20.11.2017 Rev. 20.11.2017
Possible reason Solution
• Hardware is not fully • Fully tighten the hardware.
tightened. • Adjust the bar to align it
• The pulling bar of the with the door centre line.
driver is not aligned with Adjust horizontal, vertical
•
the door centre. tracks to keep them
• The two side tracks are parallel to each other.
not parallel to each other. • Lubricate the hinges and
Hinges and winding drums the winding drums.
•
are not lubricated.
The cables tightness of the two Adjust the winding drum.
sides of the door are different
• Opener is not connected • Connect the opener to
to the power source the power source, switch
Fuse of main control board on the power, inspect
•
damaged POWER socket
• Change the same type
fuse.
Travel adjustment error Readjust open and close travel
position
Protection against obstacle • Check if there are any
during opening. obstacles.
Inspect and adjust the
•
door balance system
The closing resistance is greater
• Auto inspect or increase
than that system set load when
open and close door load
activating the barrier protection
force manually again
system
Protection against obstacle • Remove the barrier in the
beam road
during closing.
Connect the photo beam.
•
The light of photo beam
•
have been shielded;
• System started to use
photo beam, but it hasn't
been connected
• The transmitter was not • Adapt the transmitter
adapted according to the manual
The transmitter is missing Change the battery in the
• •
the battery or the battery transmitter
is discharged
The serious shield around Draw the antenna to the
• •
the garage outside of garage
• The battery power is not • Change the battery
enough
91